There are lots of tutorials around for these gorgeous handbag size tissue holders but I thought I would share the one that I have found works best for me with a couple of additions to make it extra special!
You can download the pattern templates for free on the Sew Scrumptious website here
You will need:
2 pieces of co-ordinating fabric (2 fat quarters would make several)
I used two Sew Scrumptious fabrics - Rose (Blue) Fabric which can be found here and Polka Dot (Pale Pink) fabric which can be found here
1 pack of handbag size tissues
To personalise with a name tag
Plain cream tape or ribbon
T shirt transfer paper (available in Asda and WHS stores).
Download and print out the pattern templates and cut the outside piece from your main fabric and the lining piece from your co-ordinating fabric.
Place the 2 fabric pieces together pattern sides facing and sew down each short side using a 1/4 inch seam allowance. Don't worry about one side being longer than the other and there being loose fabric on one side. That's how its supposed to look!
Turn inside out so the fabrics are now facing the right way up and press flat so that a little bit of the lining is shown either side of the main fabric.
If you want to add a personalised name label you need to make it now.
Type out what you want your label to say in a pretty font e.g. Mum or Grandma. Flip the text before you print it so it is back to front (mirror image) and then print out onto the transfer paper. I do several versions and sizes to make sure I have spares.
Cut out the name to the size of the tape and place face down on your plain tape. You should be able to see the words through the backing paper so make sure they are facing the right way. Iron on using the instructions in your pack. You usually just hold the iron over the tape for several minutes.
Wait until cool and then pull the backing paper off to reveal the text on the tape. If you are making a label for the tissue holder, don't forget to leave some plain tape on the right hand side so you can fold it under to make a double sided label to attach
Back to the Tissue Holder!
With the main fabric facing you and the spotty fabric on either side, find the middle point and place the name label as below. Don't forget to take into account your seam allowance. You don't want the name too near the top.
Fold both edges over to meet in the middle and pin.
Sew up and down the 2 short sides. I usually stitch twice to make sure it is extra strong. Use pinking sheers to trim the edges.
Turn inside out and poke out the corners. You should have a cute little label at one end.
Find a circle to draw around. The finished flower will come out about the same size as the circle you start with. I would suggest a cotton reel for this particular project.
Press each one in half and then in half again so they are quarter circles. Press flat.
Pick up the first quarter circle shape and start sewing a small running stitch close to the edge from one end of the curve to the other. Make sure you get all the layers of fabric though the stitch
When you get to the end pull tightly until the fabric gathers in and a petal shape starts to form. Continue with the next petal using the same length of thread. As you reach the end of each new petal, pull the thread and gather the petal. Ensure the petals are all next to each other as tightly as you can get them.
When you have finished petal number 5 sew a little knot at the end to keep the gathers in places but don’t cut your thread.
You need to make a back for the flower. I use a little circle of felt. Sew all around the inside edge of the flower attaching it to the felt using tiny little stitches. If you do this in a co-ordinating thread it will not really show on the front of the flower. It will be covered by a button anyway!
You can attach your button to your flower at the same time as sewing it on to the tissue holder. This is a bit fiddly. I tend to sew the button to the flower a few times first and then sew on to an item. You can use these flowers to decorate lots of different things.